Cardboard Canoe? How Do I Build One? - build a canoe trailer
For physics, I have a canoe that can hold 190 + weight of the upper floor.
The material may be used only cardboard and duct tape.
Who knows how to do this?
THANK YOU!
Monday, December 7, 2009
Build A Canoe Trailer Cardboard Canoe? How Do I Build One?
Subscribe to:
Post Comments (Atom)
Interesting project. Review the documents and their properties. Cardboard is porous, so they must think that the entire surface should be covered with tape. The board is in May or corrugated for strength, then you need to extend this principle to the basic structure.
ReplyDeleteSince you specified "canoe" We also need to build like a canoe. You want 2 sections along the edge, perhaps 10 meters x 2.5 meters was able to reduce the ends at an angle of 45 degrees. (the bow and stern) is to strengthen the long-boat, you should consider rolling over the top as a refuge. Then at the end of the strip and the bottom with some layers of tape. Now some pieces of cardboard tubes move to spread across a canoe-shaped parts. It is as wide as possible, at least 30 "at center. Use to cross at least 3 or 4 buttons. In the water, I would be 190 lbs (just a suggestion) to assist a person kneeling in the middle. If you want to Perhaps the area under the paddler increased. My biggest concern with THis the design's stability, so you may need to add a ramp.
Note that you fold and roll out of cardboard to create the structural elements, but when it is wet, you know, with the band too liberal.
No limit on the amount that you can use?
ReplyDeleteOtherwise, only a load of boxes stacked up like two feet high
Then put the edges on the sides of the head, so that things do not roll off of him